Quote Originally Posted by JarkMan View Post
yah today i was putting the clear coat on and i had a chemical reaction with the plastic paint and it cracked up ill post picks of it later today
I hate it when that happens. I've had that happen a number of times.

I'd still do the red ring though.

Do this: Take your cutting board and put a piece of masking tape about five inches long on it. Take another piece and put it next to that one, with them overlapping a bit. Keep doing that until you get it about four inches wide.

Take a glass or bottle with a mouth about 1 3/4" wide. Turn it upside down and use an X-acto knife to "draw" a circle around it. Peel up the outside tape and it will leave the circle stuck to the board.

Put your tape with the hole in it on the faceplate so that the recessed area is exposed.

Take a round object 1 1/8" in diameter and cut another circle out of the other circle. Take it and put it over the power button. (I'd actually do it a little larger than that, like 1 3/8" or the RROD painted part would be too wide. Hard to get it centered like that, though.)

Now take a couple of strips of tape about 1/4" wide and lay them in a cross.

There ya go.